Cutouts for the magnets allow you to remove the rotor. The design of the rotor allows you to put it in the position you need, replace it with a removable disk, or just conveniently paint a miniature without the risk of breaking the blades. Well, or it’s easy to repair a miniature if it’s broken. Cutouts for magnets are 3mm long and 2mm high.
This kit comes with 2 KA500 models.
Choose between hex and no hex base!
Printed in 8k using high-quality resin. Cleaned, cured, and packaged with care.
Some models may come with supports and may require assembly. Easy removal with warm water and clippers.
Models created by Sir Mortimer Bombito.
Curious about supports on 3d printed models, and removing them? Check out our resource page here!
